GPS / Biometrics

  • APM2.8 ArduPilot Mega 2.8 Flight Control Board

    1. Arduino Compatible 2.Includes 3-axis gyro, accelerometer and magnetometer, along with a high-performance barometer 3.Onboard 4 MegaByte Dataflash chip for automatic datalogging 4.Optional off-board GPS, uBlox LEA-6H module with Compass. 5.One of the first open source autopilot systems to use Invensense’s 6 DoF Accelerometer/Gyro MPU-6000. 6.Barometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties Atmel’s ATMEGA2560 and ATMEGA32U-2 chips for processing and usb functions respectively.

    Read more
  • GPS Arduino Shield

    • Micro SD Interface
    • UART Interface
    • Power Voltage: 5  VDC
    • Shield Functions: Storage, Wireless
    • Operating Voltage: Digital 3.3 V or 5 V
    • Operation Temperature Range: -40° C to +85° C
    • Board Size: 56 x 54 mm
    • Weight: 45 g
    Read more
  • NAZA M Lite with GPS

    All-in-One Design • GPS Module Available/Accurate Position Hold • Low Voltage Protection • 6 Supported Multi-rotor Types • Advanced Attitude Stabilize Algorithm • Intelligent Orientation Control (IOC) • Motor Arm and Motor Dis-arm • Built-in Gimbal Stabilization Function • Multiple Flight Control Mode/Intelligent Switching • Failsafe Mode • Support Futaba S-Bus and PPM Receiver • Remote Adjustment Specs: Supported Multi-Rotor: Quad-rotor I4, X4, Hex-rotor I6, X6, IY6, Y6 Supported ESC output: 400Hz refresh frequency Recommended Transmitter: PCM or 2.4GHz with minimum 4 channels Working Voltage Range: MC: 4.8V~5.5V, VU Input: 7.2V~26.0V (recommended 2S~6S Lipoly) Power Consumption: MAX: 1.5W (0.3A @ 5V), Normal: 0.6W (0.12A @ 5V) Operating Temperature: -10°C ~ 50°C Assistant Software System Requirement: Windows XP sp3/Windows 7/Windows 8 Dimensions: MC: 45.5×31.5×18.5mm, VU: 32.2×21.1×7.7mm, GPS & Compass: 46mm (diameter)x9mm Weight:MC: 25g, VU: 20g, GPS: 21.3g Flight Performance: Hovering Accuracy (GPS Mode): Vertical: +/-0.8m, Horizontal: +/-2.5m Max Yaw Angular Velocity: 200°/s Max Tilt Angle: 45° Ascent/Descent: +/-6m/s

    Read more
  • Polar Heart Rate Monitor Interface

    • Multiple interfaces: USB, Logic-level serial and I2C
    • Dual heart rate processing algorithms: averaged and raw
    • Uses the RMCM01 Polar OEM receiver
    • Compatible with coded and non-coded Polar transmitters including T31, T31C, T61C and Wearlink®
    • 32-entry heart rate data history buffer
    • Four 8-bit ADC inputs
    • Up to a 5 channel digital input/output utility port
    • Simple command/response interface
    • Programmable power-on default operation
    • Only works with one transmitter (HRM) in range
    Read more